User's Manual
Table Of Contents
- Welcome to the Airespace Product Guide!
- OVERVIEWS
- About the Airespace System
- About the AireOS
- Single-Airespace Switch or Appliance Deployments
- Multiple-Airespace Switch and Appliance Deployments
- About AireOS Security
- About Airespace Wired Security
- About AireWave Director Software
- About the Master Airespace Switch or Appliance
- About the Primary Airespace Switch or Appliance
- About Client Roaming
- About External DHCP Servers
- About Airespace Mobility Groups
- About Airespace Wired Connections
- About Airespace WLANs
- About File Transfers
- About Power Over Ethernet
- About Airespace Switches and Appliances
- 4012 and 4024 Airespace Wireless Switch Models
- 4101 and 4102 Airespace WLAN Appliance Models
- Airespace Switch and Appliance Features
- Airespace Switch and Appliance Model Numbers
- Airespace Wireless Switch Direct Connect Mode
- Airespace Switches and Appliances in Appliance Mode
- Airespace Wireless Switch Hybrid Mode
- About the Distribution System Port
- About the Service (Management) Port
- About the Startup Wizard
- About Airespace Switch and Appliance Memory
- Airespace Switch and Appliance Failover Protection
- Switched Network Connection to the Airespace Switch or Appliance
- Enhanced Security Module
- About Airespace Access Points
- About Airespace AP Models
- About Airespace AP External and Internal Antennas
- About Airespace AP LEDs
- About Airespace AP Connectors
- About Airespace AP Power Requirements
- About Airespace AP External Power Converter
- About Airespace AP Mounting Options
- About Airespace AP Physical Security
- About Airespace AP Monitor Mode
- About Third-Party Access Points
- About Rogue Access Points
- About the Airespace Control System Software
- About the Airespace Web Browser Interface
- About the Airespace Command Line Interface
- About the Airespace System
- SOLUTIONS
10/10/03 FCC Statements for Airespace APs
90-100584-004 Airespace Product Guide x
FCC Statements for Airespace APsFCC St atements for Airespace APs
This section includes the following FCC statements for the Airespace AP:
• Class A Statement
• RF Radiation Hazard Warning
• Non-Modification Statement
• Deployment Statement
Class A StatementClass A Statement
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
RF Radiation Hazard WarningRF Radiation Hazard Warning
To ensure compliance with FCC RF exposure requirements, this device must be installed in a location
such that the antenna of the device will be greater than 20 cm (8 in.) from all persons. Using higher
gain antennas and types of antennas not covered under the FCC certification of this product is not
allowed.
Installers of the radio and end users of the Airespace Wireless Enterprise Platform must adhere to the
installation instructions provided in this manual.
Non-Modification StatementNon-Modification Statement
Use only the supplied internal antenna, or external antennas supplied by the manufacturer. Unautho-
rized antennas, modifications, or attachments could damage the badge and could violate FCC
regulations and void the user’s authority to operate the equipment.
Note: Refer to the Airespace System Release Notes for 802.11a external antenna information.
Contact Airespace, Inc. for a list of FCC-approved 802.11a and 802.11b/g external antennas.
Deployment StatementDeployment Statement
This product is certified for indoor deployment only. Do not install or use this product outdoors.