Use and Care Manual

PAGE:2/ 4
There are four grommets attached in
the hardware package. Insert the
grommets into the holes in the mounting
bar. Then install the mounting bar onto
the mounting plate using lock nuts and
washers.
Attach the Blade to the Blade Holder
with Washers and Blade Screws.
Repeat for remaining fan blades.
Mounting Plate
Motor
Fig.5
Mounting Bar
Grommet
Washer
Lock Nut
Fig.6 Fig.6-a Fig.6-b
Mounting Plate
Mounting Plate
Peg
Peg
Clip
Housing
Housing
Slot
Hook
Slide the Housing up over the Motor. Align the Pegs on the Mounting Plate with
the Slots on the Housing
Note: The pegs on the mounting plate will be tightly secure with the clips on the
housing.
(Fig.6-a & Fig.6-b)
(Fig.6-a)
. Rotate the Housing clockwise to tightly secure.
Rotate
Housing
Blade
Blade Holder
Blade Screw
Fig.7
Assembly without fan light
Make sure the wires of the fan light in
the switch box are capped with wire
nuts. Secure the switch box with the
switch box screws.
Note: To install the fan light, skip
this step and proceed to Fig. 10.
Attach blades to blade holders by
using blade screws and washers.
Fig.8
Blade Holder
Motor Screw
Switch Box Screw
Switch Box Cover
Fig.9
Fig.10
Fan Light Installation:
Install bulbs (included). See relamping
label at socket area or packaging for
maximum allowed wattage.
Connect the terminals from the fan
light to the terminals from the switch
box.
--- The blue wire from the switch box
to the black wire from fan light.
--- The white wire from the switch box
to the white wire from fan light.
Carefully put the wires into the switch
box.
Bulb Type B Max.60W
(included)
Switch Box
Switch Box Screw
Fan Light
Fig.12Fig.11
Install the fan light to the switch box
with the switch box srews.
Switch Box
Switch Box Screw
Fan Light
Terminal
F A N C O
101203