User manual

U-Ground User Manual - Joystick

5.1

Connecting the Joystick to the Main connector

To connect the Futaba emitter to U-Ground , a manufactured harness is usually served with the

U-Ground installation kit. If the customer needs to manufacture a custom harness, the pin-out

of the Futaba connector is described in this section.

Using the supplied aerial military connector, the

connections between U-Ground and Futaba military

connector (as detailed in Figure 5) should be

established as shown in following table (Table 2)

Pin in Futaba

Connector

Function Connect to

1 GND Pin 4, 8, 11, 15 or 36

2 Signal Pin 7 (Blue)

3 Vin

6.5 -28V (Referred to

GND)

Table 2: Futaba connections