User manual

U-Ground OneBoard User Manual - Joystick

Using the supplied aerial military connector the

connections between U-Ground OneBoard and

Futaba military connector (as detailed in Figure 5)

should be established as shown in following table

(Table 3)

Pin in Futaba

Connector

Function Connect to

1 GND

Pin 4

(White-Black-Brown; A 'Y'

may be required)

2 Signal

Pin 27

(White-Brown)

3 Vin

Connect to power supply

for joystick (6,5V-36V)

Table 3: Futaba connections

5.2

Configuration for Futaba Joystick

Airelectronics will supply you a Futaba configured for U-Ground OneBoard, modified with a

military connector. Configuration should be not altered for the proper operation of the system.

For reference, we include hereby the proper configuration for a Futaba:

Feature Proper Setting

Modulation PCM/PPM (depends on

model)

Channel 5 switch Switch D

Channel 7 switch Switch B

Sub-Trim All set to 0

Dual Rates 100%

Exponential 0%

End points 100%

Reverse Normal for all channels

Throttle-cut Inhibited

Failsafe Normal in all channels

Modulation must be set to PCM in Futaba T7CP variant to work with U-Ground OneBoard . In

case you need to adjust modulation, follow the following instructions

Figure 5: Military connector in

Airelectronic's modified Futaba