User manual

U-See User Manual - Settings Menu
2.12.10.2 Data Presentation
Customization of data presentation in State window is also allowed through this dialog, a
drop-drown menu allows the selection of data presentation mode shown in the surfaces
window (see Section 2.8.5 State ).
Also in this section, is the selection of preferred units for every magnitude. See 2.4 Units
and locale for the accurate definition of available units.
Users of the imperial measurement system should check that the definition of the units
match their expected values before operating the system. Specially if you use miles for
distance measurement, as there is no “standard mile” and its definition changes from
country to country.
2.12.10.3 Maps & DEM configuration
This section allows to fine tune symbology presented on the map. A check is available to
turn off/on:
• Calculated camera pointing target
• UAV Trail: A historic of aircraft position. Climbs at 5 m/s or higher will be painted
completely red, descends of 5 m/s or more will be completely blue.
• Show Relative-GPS Info (Optional feature): This may not apply to your U-See
version. This control shows/hides all Relative GPS symbology display on map. This
includes moving base position as reported by relative GPS subsystem, its overlay
and the base trail.
• Overlay on Map: Shows/hides on map basic information overlay.
• GPWS Overlay: Shows/hides GPWS coloured pattern on map. This doesn't affect the
TERRAIN alarm or the GPWS bar diagram on the altitude sliding bar.
Map theme used for map display can be changed between the installed options in the
system. Custom maps can be added using the MapManager utility distributed along U-See.
2.12.10.3.1 Dem configuration
Digital Elevation Model(DEM) Configuration is accessed through the “Dem configuration”
button located on the right bottom corner of the window.
Document Version 1.25 70
Figure 62 Maps & DEM Configuration