User manual

U-See User Manual - Settings Menu

With the 'Sync Barometric Altimeter & GPS' button in the 'Altimeter' section, the system

altitude is adjusted to reflect precisely the instantaneous GPS altitude at that moment.

The system corrects its barometric altitude using information from the navigation fix as an

input, however, if GPS initial navigation fix is of poor quality, a wrong barometric altitude

correction may be introduced into the system. This button forces the recalculation of such

barometric correction, thus correcting the problem.

In the Dynamic section, errors coming from pitot installation can be compensated. This

dialog allows to increase and decrease pitot indication linearly from -20% to 20%

compared to standard pitot sensor calibration.

To be made permanent, the changes in the section 'Dynamic' need to be saved to the non-

volatile memory of the autopilot through the Save Changes entry in the settings menu.

The actions commanded through this settings window shall never be commanded

while an aircraft is in flight. Shall any doubt about the usage of this dialog arise, please

Proper operation of the Air Data System is of the utmost importance for a safe operation of

the system.

2.12.7

Servos

While the Airelectronics staff will adjust the servos on your UAV for you as part of the

adaptation, you may need to change a servo or move the autopilot among different units

of the same model of aircraft. With the servo adjustment mode, you will be able to adjust

the mechanical travels for the particular servos you use.

Document Version 1.25 64

Figure 56: Air Data System settings window

Figure 58: Servo adjusment window with simple

configuration shown

Figure 57: Servo adjustment window with

advanced configuration shown