User manual

U-See User Manual - Settings Menu

• Relative: Values that do not need to change sign will be adjusted as a percentage to

increase or decrease over current value.

Below every parameter a short description of the parameter effect and its unit will be

shown.

To make the parameters change permanent settings → save settings has to be used. If a

mistake is made, it is possible to power-cycle the autopilot to undo it.

2.12.2

Configure GCS Hardware(Optional)

This is an optional feature, so this section may not apply to your U-See version

Tracking enabled U-Grounds can be configured through this option. Check specific

U-Ground documentation for the usage of this feature.

2.12.3

Manual Trims

The manual trim dialog allows the user to change the surfaces trim of the vehicle: this

allows to deflect surfaces a constant amount through all the flight envelope, thus

eliminating movement tendencies acquired through change of CoG, damage to

aerodynamic surfaces due to wear, etc.

For each command there are two buttons that modify the trim status and automatically

upload the new values to the vehicle, meanwhile the button “Get” downloads the current

values of the trims. Keeping the button pressed will continue to trim in that direction,

accelerating the trim value with time.

Document Version 1.25 61

Figure 51: Relative Mode change

Figure 52: Absolute mode

Parameters accessed through this dialog can fundamentally change

the behaviour of the autopilot. They may provoke a leave of

controlled flight and proper training and knowledge is needed to

operate this feature.

If you have any doubt, please, contact Airelectronics for support

before risking your aircraft.