User manual

U-See User Manual - Command Menu
2.10.1.6.5 Landing mode
The UAV changes its mode to landing in three cases:
– The Computer Operator clicks on Landing Button.
– The Preflight Bingo Time is reached.
– There is a Communication failure between the U-Ground and the U-Pilot Autopilot.
It is mandatory to properly set the Runway checking its altitude and Heading before
taking-off. In case of a communication failure the UAV will automatically go to this point.
The landing path is automatically recalculated with all the parameters set to the UAV
requirements, the end user do not have to worry about it.
The UAV will return to the Runway Point at a safe altitude, once this point is reached, it will
command UAV commanded yaw equal to the Runway Heading and it will start descending
at a controlled rate.
Once the Ground has been reached and the UAV has landed, the External Pilot must kill the
engine and then move the B switch to down position, taking control in Manual mode and
then disconnecting power.
2.10.1.6.6 Servos Adjustment mode
This mode is used to adjust the mechanical maximum minimum and neutral position of the
servos. It is detailed in Servos section.
This mode shall never be commanded while in flight, as it disconnects servos from the
autopilot control.
Document Version 1.25 53