User manual

U-See User Manual - View Menu: Real time information windows
The 3D visualization can be deactivated in order to use a standard Artificial Horizon just
unchecking 3D View on the top of the window. Some HUD features, such as flight director
can be switched on and off through its respective checkboxes.
Note that the 3D representation is only valid for visualization purposes and cannot be used
for manual flights, as the precision of the 3D view is given by the Digital Elevation Model,
and it is not 100% accurate.
2.8.5
2.8.5
State
State
To access to the State window click on the toolbar or go to
View→State.
The State window is divided in two sections, alarms and
surfaces information. The alarms section occupies the upper
section, and the surfaces information is at the bottom region.
2.8.5.1 Alarms section
On the alarms section is possible to see if all systems
are working properly. To start a flight is necessary that
all alarms are set in green. Notice that the
magnetometer alarm (MAG) does not appear when
using a fixed wing vehicle, and the dynamic pressure
alarm (QD) does not appear when using a rotary wing
vehicle.
A system operating properly will be reported by a green
background. Any system in critical abnormal condition
will be drawn with a red background. Systems that are
operational but with some problem or limitation are
presented with an orange background. Those system
currently not being checked are displayed with a grey
background.
Please note that the voltages alarms may be bounded by limits defined in U-See instead of
the autopilot itself (See 2.12.10 U-See settings ).
The table hereafter describes the meaning of the alarms.
Document Version 1.25 25
Figure 21: Alarms section of the
State Window
Figure 20: State window