Instructions / Assembly

FINISHING THE INSTALLATION

CLOSE-TO-CEILING MOUNTING

Step 1. Remove the motor assembly from the mounting bracket hook and engage the key holes to the two screws

previously loosened. (Fig. 18)

Step 2. Install the screw previously removed and tighten all four screws.

Step 3. Raise up decorative ring and line up the 2 tabs with the 2 grooves on the motor housing. Once lined up, slide the

decorative ring and secure it to the motor housing until snug. Repeat this procedure with the remaining decorative ring.

STANDARD CEILING MOUNTING

Step 1. Remove 1 of the 2 screws from the bottom of the hanger bracket and loosen the other one half a turn from the

screw head. (Fig. 17)

Step 2. Slide the canopy up towards the hanger bracket and place the key hole on the canopy over the screw on the

hanger bracket, turn canopy until it locks in place at the narrow section of the key holes.

Step 3. Align the circular hole on canopy with the remaining hole on the hanger bracket, secure by tightening the two

set screws.

Note: Adjust the canopy screws as necessary until the canopy and canopy cover are snug.

OUTLET BOX

HANGER

BRACKET

HANGER

BALL

CANOPY

COVER

FIG. 17 FIG. 18

SCREWS

MOUNTING

BRACKET

DECORATIVE

RINGS