Specifications

1
SECTION
Coast to Coast
CARAVAN & LEISURE
FIAMMA AWNING RAIN GUARDS
FIAMMA WINDING HANDLE TELESCOPIC
Awning rain guards are a great solution to prevent water from
dripping behind the space where your Fiamma awning has been
mounted. Made of rubber, the rain guard is installed onto the
awning case (no need to remove the awning). Comes in
two widths.
200-04800 - FIAMMA
AWNING RAIN GUARD L
Suited to awnings that have
been fitted using one of
the adapter brackets that
resulted in a gap of up to 9cm
between the awning case
& the RV wall. Can also be
used on curved walls. Sold
per metre.
200-04810 - FIAMMA
AWNING RAIN GUARD S
For awnings installed with the
standard AS120 bracket on
flat walls. Fits the 1.6cm gap
between the flat wall of the
RV & the back of the awning
case. Sold per metre.
200-04896
This telescopic handle is
standard delivered with the
F45TiL awning. Made from
light aluminium, it is ideal
for high motor homes or
caravans, allowing users to
easily unwind their awning
without stretching. Weighs
only 1.32kg. Min length is
154cm but can extend up to
240cm.
200-04898
This 123cm crank handle is
standard delivered with F45S
awnings up to 400cm. It has
a folding handle & is made
of ultra light aluminium. It
can be cut down if required
& weighs only 0.4kg. Comes
with a clip for storage inside
your RV.
200-04900
The shortest of Fiamma’s
crank handles the 51cm
version is also made of light
aluminium, meaning it only
weighs 0.24kg. Ideal for
smaller/ lower RV’s. It also
comes with a clip for storage
inside your RV.
200-04901
Made of aluminium, these
are installed on the outside
wall of your RV, allowing
you to mount the legs of
awning on the side of your RV
(instead of vertically dropping
to the ground). Suitable for
Fiamma F45S, F45TiL, F65,
Caravanstore & F35 awnings.
Comes in a set of 2.
FIAMMA WINDING HANDLE STANDARD 123CM
FIAMMA WINDING HANDLE SHORT 51CM
FIAMMA ALU WALL BRACKETS FOR AWNING LEGS
018
FIAMMA ADAPTER BRACKETS