Use and Care Manual

SPECIFICATIONS
Important Warnings - Grinders & Cut-Off Tools
Model No.
Free Speed
(RPM)
Motor
(HP)
Collet /
Wheel-
Size (in)
Gears
Cutting
Capacity
Exhaust
Weight
(lbs.)
Length
(in)
Air Cons.
(CFM)
Rec. Hose
Size
(in.)
Air Inlet
(in.)
6520 18,000 1/2 3 Direct Drive
3/4" Rolled
Steel / 18 Gauge
Rear 1.6 7.0 4 3/8 1/4 NPT
Tools of this class operate on a wide range of air pressure. It is recommended that air pressure of these tools measures 90 PSI at the tool while running free. Higher
pressure and unclean air will shorten the tool’s life because of faster wear and may create a hazardous condition and void the warranty. Water in the air line will
cause damage to the tool. Drain the air tank daily. Clean the air inlet lter screen on at least a weekly schedule. The recommended hookup procedure can be viewed
in the illustration below. The air inlet, used for connecting air supply, has standard 1/4” NPT American Thread. Line pressure should be increased to compensate for
unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D. and ttings should have the same inside dimensions.
Air Supply