SDS

D8284821 v4.0
Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
6. Accidental release measures
same hazard as the spilled product. Note: see Section 1 for emergency contact
information and Section 13 for waste disposal.
7. Handling and storage
Conditions for safe storage,
including any
incompatibilities
Store in accordance with local regulations. Store in a segregated and approved area.
Store in original container protected from direct sunlight in a dry, cool and well-ventilated
area, away from incompatible materials (see Section 10) and food and drink. Eliminate
all ignition sources. Separate from oxidizing materials. Keep container tightly closed
and sealed until ready for use. Containers that have been opened must be carefully
resealed and kept upright to prevent leakage. Do not store in unlabeled containers.
Use appropriate containment to avoid environmental contamination.
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Persons with a
history of skin sensitization problems should not be employed in any process in which
this product is used. Do not get in eyes or on skin or clothing. Do not ingest. Avoid
breathing vapor or mist. Use only with adequate ventilation. Wear appropriate
respirator when ventilation is inadequate. Do not enter storage areas and confined
spaces unless adequately ventilated. Keep in the original container or an approved
alternative made from a compatible material, kept tightly closed when not in use. Store
and use away from heat, sparks, open flame or any other ignition source. Use
explosion-proof electrical (ventilating, lighting and material handling) equipment. Use
only non-sparking tools. Empty containers retain product residue and can be hazardous.
Do not reuse container.
:
Precautions for safe handling
benzyl alcohol
AIHA WEEL (United States, 5/2018).
TWA: 10 ppm 8 hours.
benzyl acetate
ACGIH TLV (United States, 3/2018).
TWA: 10 ppm 8 hours.
TWA: 61 mg/m³ 8 hours.
(R)-p-mentha-1,8-diene
AIHA WEEL (United States, 5/2018).
TWA: 30 ppm 8 hours.
8. Exposure controls/personal protection
Ingredient name
Exposure limits
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
Appropriate engineering
controls
:
Use only with adequate ventilation. Use process enclosures, local exhaust ventilation or
other engineering controls to keep worker exposure to airborne contaminants below any
recommended or statutory limits. The engineering controls also need to keep gas,
vapor or dust concentrations below any lower explosive limits. Use explosion-proof
ventilation equipment.
Control
Individual protection measures
Occupational exposure limits
5/15
05/08/2019
Date of issue
:
SDS #
8278319_D8284821_NA
:
Code #
D8284821 v4.0
: