RAIL LOCK™ SPRING COMPRESSOR User Instruction Manual For Spring and Gas Piston Rifles and Pistols V1 03/16
Contents Parts of the Rail Lock™ compressor............................ 3 Disassembling your rifle or pistol..............................4-6 Assembling your rifle or pistol..................................... 7 Warranty......................................................................8 ! WARNING: ALWAYS BE SURE THE AIRGUN IS POINTED IN A SAFE DIRECTION. ! WARNING: THIS PRODUCT IS INTENDED FOR USE BY TRAINED PROFESSIONALS ONLY.
Parts of the Rail Lock™ Compressor Quick Release Button Hole for Allen Key Bumper Plug Threaded Rod Rail Mounting Grooves Rotation Locking Set Screw Rear Rail Screw Front Rail Screw 2.5mm Allen Key 4mm Allen Key © Air Venturi 2017 / www.airventuri.
Disassembling Your Gun with the Rail Lock™ 1) Remove the rifle or pistol action from the stock. 2) Slightly loosen the rotation locking set screw on the 1 rear of the Rail Lock™ compressor by turning counterclockwise. 3) Slightly loosen the rear rail screw on the Rail Lock™ 2 compressor by turning counter-clockwise. 4) Loosen the front rail screw enough to fit the Rail 3 ™ Lock compressor onto the scope rail, by turning counter-clockwise.
Disassembly with the Rail Lock™ (cont.) 7) Make sure that the threaded rod is properly aligned with the back of your rifles compression tube. You may need to loosen the rear rail screw slightly to make minor angle adjustments for proper alignment. 8) Once proper alignment is achieved and the rail screws are tightened down to the scope rail, secure the rotational set screw at the rear of the Rail Lock™ compressor by turning it clockwise.
Disassembly with the Rail Lock™ (cont.) 11) When the rod is properly positioned and secured, you will want to free the end cap by removing whatever pins/screws your gun has to retain the end cap. In order to do this, you will need to turn the rod via the allen key in the back of the rod clockwise (fig. 11a). This will 11a remove the tension from the pins/screws and allow you to safely remove them (see fig. 11b).
Assembling Your Gun with the Rail Lock™ 1) Position the internal components of your rifle or pistol in the proper order in the compression tube. 2) Attach the Rail Lock™ compressor to the scope mounting rail on your gun following steps 2 through 9 in the disassembly section. 3 3) Once the threaded rod is aligned properly and slight pressure is applied to the end cap, begin turning the rod clockwise with the allen key through the hole in the back of the rod.
Warranty One-Year Limited Warranty This product is warranted to the retail consumer for one year from date of retail purchase against defects in material and workmanship. In the unlikely event there are any defects in materials or workmanship in the first twelve (12) months after retail purchase, we will repair or replace the defective items under warranty. What is covered: Replacement parts and labor. Transportation charges to consumer for repaired product.
Notes © Air Venturi 2017 / www.airventuri.
Notes © Air Venturi 2017 / www.airventuri.
Notes © Air Venturi 2017 / www.airventuri.
336U AIR VENTURI 5135 Naiman Parkway, Cleveland, OH 44139 216-292-2570 • fax 216-373-0086 BLK
