Instruction Manual

2018 / www.airventuri.com / 216-292-2570

Operating the Lights

The blue lighting on the underside of your Nomad II

will only come on once the POWER/RESET button

has been depressed, turning the unit on.

1) Locate the red ON/OFF switch in the middle of the

LED light panel on the underside of the unit.

2) If you want the LED lights to turn on while the unit is

operational, depress the " " symbol on the

red switch (g. 1).

3) If you want the LED lights turned off

(g.3) while the unit is operational, depress

the " " symbol on the red switch (g. 2).

Installing the Feet Extensions

Included with your Nomad II are feet extensions that

will position the unit higher off of the surface the

unit is on. This will allow for easier access to the

underside of the unit (specically the LED light switch

and the Moisture Release Valve) should you require it.

1) Remove the rubber feet by turning them counter-

clockwise, until they are removed from the unit (g. 1).

2) Place one extension disc onto the threaded screw.

(g. 2).

3) Replace each foot with the extension by turning them

clockwise (g. 3a).until they are tight against the bottom

of the unit. (g. 3b).

1: LED lights On

2: LED lights O