Instruction Manual

2018 / www.airventuri.com / 216-292-2570

13b

Operation Instruction: 12V Battery

8) Once these steps are complete, depress the

POWER/RESET button.The LOAD gauge will illuminate

and the compressor fans will begin to run (g. 8).

9) Once the fans are running, depress the ON/OFF

button to begin lling (g. 9).

Note: You can stop the ll process at any time by depressing the ON/

OFF button. If you do stop the ll for any reason, you MUST bleed the

pressure in the line before resuming lling. If you DO NOT bleed the

pressure in the line and just depress the ON/OFF button to resume

lling, the Nomad will automatically stop after a few seconds of running.

10) Once the pre-set ll pressure is reached, the

compressor will stop (g. 10).

NOTE: The cooling fans will continue to run.

11) Release/Bleed the pressure in the system by turning

the pressure release/bleed screw counter-clockwise

(g. 11).

12) Once the pressure is released and the pressure

gauge on the compressor reads 0 PSI/BAR, disconnect

the hose from the lled device by pulling back the collar

on the female quick disconnect tting and at the same

time, pulling it off of the male tting it was connected to

(g. 12).

13) To power down your Nomad II, depress the

POWER/RESET button (g. 13a) and the LOAD gauge

and compressor fans will turn off. Unplugging the yellow

connecter (g. 13b) from your Nomad II will turn off the

power converter fan.

CAUTION:

Air and/or liquid may be released at

high velocity from the bottom of the unit. Keep ngers/

hands/eyes clear from the bottom of the unit when

opening the pressure release/bleed screw.

13a