Instruction Manual

Operation Instruction: 110V or 220V outlet

2018 / www.airventuri.com / 216-292-2570

13b

CAUTION:

Air and/or liquid may be released at

high velocity from the bottom of the unit. Keep ngers/

hands/eyes clear from the bottom of the unit when

opening the pressure release/bleed screw.

9) Once the fans are running, depress the ON/OFF

button to begin lling (g. 9).

Note: You can stop the ll process at any time by depressing the

ON/OFF button. If you do stop the ll for any reason, you MUST

bleed the pressure in the line before resuming lling. If you DO

NOT bleed the pressure in the line and just depress the ON/OFF

button to resume lling, the Nomad II will automatically stop after a

few seconds of running.

10) Once the pre-set ll pressure is reached, the

compressor will stop (g. 10).

NOTE: The cooling fans will continue to run.

11) Release/Bleed the pressure in the system by

turning the pressure release/bleed screw counter-

clockwise (g. 11).

12) Once the pressure is released and the pressure

gauge on the compressor reads 0 PSI/BAR,

disconnect the hose from the lled device by pulling

back the collar on the female quick disconnect tting

and at the same time, pulling it off of the male tting

it was connected to (g. 12).

13) To power down your Nomad II, depress the

POWER/RESET button (g. 13a) and the LOAD

gauge and compressor fans will turn off. Unplugging

the three prong connecter (g. 13b)from your 110V

outlet will turn off the power converter fan.

13a