Instruction Manual
1) Plug the power cord into the Nomad II (g. 1). DO NOT
plug the three prong connector into an active wall outlet yet.
2) Plug the 110V three prong connector into your wall outlet
(g. 2). Once plugged in, the fan on the power converter
will turn on. The compressor fans and LOAD gauge will not
come on yet.
NOTE: If connecting to a 220V outlet, an outlet adapter will be necessary to
use the included power cord.
3) Set the desired ll pressure via the dial on the top of the
pressure gauge (g. 3).
4) Make sure the connection between the female quick
disconnect on the hose and the male connection on the
compressor are tight (g. 4).
5) Close the bleed/pressure release valve by turning it
clockwise until it is tight (g. 5).
6) On the underside of the unit, locate the “Moisture Release
Valve” and turn clockwise (g. 6) until tight to close it.
7) Connect the output hose to the device you wish to ll via
the female quick disconnect tting (g. 7).
PLEASE NOTE: If you are lling a PCP airgun from empty, you may need to
cock the gun before starting the ll process. Consult the owner's manual of
your airgun for further instructions.
8) Once these steps are complete, depress the POWER/
RESET button. The LOAD gauge will illuminate and the
compressor fans will begin to run (g. 8).
5
Operation Instruction: 110V or 220V outlet
1
2
4
5
© Air Venturi
®
2018 / www.airventuri.com / 216-292-2570
CAUTION:
Always check and make sure the collar
on the female quick disconnect is in the forward position
and secure on the male tting you are connecting it to.
It is recommended that you check the connection by
attempting to pull the female and male ends apart while
the collar on the female tting is in the forward position.
3
6
7
8
DO NOT OVERFILL AIR
CYLINDERS OR AIR GUN
TANKS, AS THIS CAN CAUSE SERIOUS INJURY OR
DEATH. NEVER SET THE OUTPUT PRESSURE/AUTO
SHUT OFF ABOVE 4500 PSI (310 BAR).
WARNING
!
!
CAUTION:
Always check and make sure the collar
on the female quick disconnect is in the forward position
and secure on the male tting you are connecting it to. It is
recommended that you check the connection by attempting
to pull the female and male ends apart while the collar on
the female tting is in the forward position.
!