Instruction Manual

Output Air Filter Replacement

NOTE: It is recommended that you replace the Air

Filter every 2-3 hours of use. Should you require extra

Air Filters, they can be purchased through Air Venturi.

(216-220-1180).

1) Remove the lter and hose assembly from the

compressor unit by pulling back the collar on the female

quick disconnect tting and pulling the lter away from

the compressor (g. 1).

2) Find the seam in the lter housing (g. 2.1), twist the

large half counter-clockwise, unscrewing it until the unit

separates (g. 2.2).

3) Locate the cartridge lter inside of the large half of

the lter housing (g 3.1). Remove it with tweezers or by

puncturing it with an allen key and pulling it out of the

housing (g. 3.2).

4) Once the used lter is removed, replace it with a new

cartridge lter by pressing the new lter into the large

half of the housing (g. 4).

5) Reassemble the lter housing by screwing the small

and large halves together, turning the large half

clockwise until it is hand tight (g. 5).

6) Re-attach the female quick disconnect to the

compressor by pulling back on the collar on the female

while pressing it onto the male tting. Make sure the

collar is in the forward/locked position before attempting

to run the compressor.

2.2

3.1

3.2

2.1

2018 / www.airventuri.com / 216-292-2570

Lubricating your Nomad II Compressor

Locate the lubrication hole on the left hand side of the unit. Using the included oil

applicator bottle, apply 2-3 drops of silicone oil every

5 lls or 1.5 hours of use (whichever comes rst).

The “LOAD” gauge on the top of the Nomad II can also be

used to determine oil application intervals. If the LOAD

gauge reaches 28 during operation, it is necessary to

apply silicone oil. The Nomad II will automatically shut off if the LOAD gauge exceeds 29.

IMPORTANT: Use only silicone oil to lubricate the compressor. The use of any other oil/lubricant is not

recommended and may void your warranty.