Instruction Manual
1) Plug the power cord into the power converter. DO NOT
plug the three prong connector into an active wall outlet
yet.
2) Connect the power converter to the compressor via the
plug on the right hand side of the unit.
3) Plug the 110V three prong connector into your wall
outlet. (g 3.1) Once plugged in, the power converter and
compressor fans will begin to run, the LOAD gauge will
turn on.(g 3.2)
NOTE: If connecting to a 220V outlet, an adapter will be necessary to use
the included power cord.
4) Set the desired ll pressure via the dial on the top of the
pressure gauge.
5) Make sure the connection between the female quick
disconnect on the hose and the male connection on the
compressor are tight.
6) Close the bleed/pressure release valve by turning it
clockwise until it is tight.
7) On the underside of the unit, locate the “Moisture
Release Valve” and turn clockwise until tight to close it.
8) Connect the output hose to the device you wish to ll
via the female quick disconnect tting.
PLEASE NOTE: If you are lling a PCP airgun from empty, you may need
to cock the gun before starting the ll process. Consult the owner's manual
of your airgun for further instructions.
5
Operation Instruction: 110V or 220V outlet
1
3.1
4
5
2
© Air Venturi
®
2018 / www.airventuri.com / 216-292-2570
!
CAUTION:
Always check and make sure the collar
on the female quick disconnect is in the forward position
and secure on the male tting you are connecting it to.
It is recommended that you check the connection by
attempting to pull the female and male ends apart while
the collar on the female tting is in the forward position.
CAUTION:
Always check and make sure the collar
on the female quick disconnect is in the forward position
and secure on the male tting you are connecting it to. It is
recommended that you check the connection by attempting
to pull the female and male ends apart while the collar on
the female tting is in the forward position.
3.2
6
7
8
DO NOT OVERFILL AIR
CYLINDERS OR AIR GUN
TANKS, AS THIS CAN CAUSE SERIOUS INJURY OR
DEATH. NEVER SET THE OUTPUT PRESSURE/AUTO
SHUT OFF ABOVE 4500 PSI (310 BAR).
WARNING
!
!