Instruction Manual

/ www.airventuri.com / 216-292-2570

BATTERY INSTALLATION

1) To open the target box, locate the button

on the right hand side of the target. Press the

button towards the back of the target until the

target box opens.

(Note: The top of the target box is spring loaded and will open

with force. Be sure to keep all body parts away from the top of

the box while opening.)

2) With the target box opened, locate the two (2)

phillips head screws on the battery cover. Using

an appropriate screwdriver, remove the screws

by turning counter-clockwise.

3) With the screws removed, lift the battery

cover o󰀨 of the target. It may be necessary to

pull down slightly on the top of the target to allow

the battery cover to clear the ON/OFF switch.

4) Install three (3) AA (LR6) batteries paying

close attention to the polarity markings on the

battery housing. Once installed, you can check

to see if your target is functioning by depressing

the ON/OFF switch. If the batteries are

connected properly, the light next to the switch

will turn on.

5) Replace the cover and secure it with the two

(2) phillips head screws.

RISK OF EXPLOSION IF THE

BATTERY IS REPLACED BY

AN INCORRECT TYPE. DO

NOT MIX OLD AND NEW

BATTERIES OR BATTERIES

OF A DISSIMILAR TYPE.

CAUTION:

FIG. 1

FIG. 2

FIG. 3

FIG. 4

FIG. 5