User`s manual

MAINTENANCE
44..
Scrub grooves inside the transport with a small
brush, paying close attention to the areas just
above the chemistry line, where crystallization
occurs. Rinse to remove deposits. See Fig. 12.
55..
Scrub and rinse the gears on the back of the transport.
66..
With a dry, lint-free cloth wipe off any moisture
from the shutter and the film inlet area and grill.
IImmppoorrttaanntt:: TThheessee aarreeaass mmuusstt bbee ddrryy bbeeffoorree
pprroocceessssiinngg ffiillmm..
77..
Clean the dryer transport rollers if dry, white chem-
istry residue is evident. Follow the procedure
detailed under Quarterly Maintenance #12.
CChhaannggee PPeerrii--PPrroo CChheemmiissttrryy
Change Developer and Fixer every two weeks or
every 300 - 350 films, whichever comes first.
CCaauuttiioonn:: NNeevveerr ooppeerraattee tthhee PPeerrii--PPrroo IIIIII wwiitthhoouutt lliiqquuiidd iinn tthhee ttaannkkss..
11..
Change the water. Follow the steps for changing water under Daily
Maintenance.
 If the wash tank is particularly soiled or slimy, it must be thoroughly
cleaned and rinsed. To do this, first remove the film transport.
 If the tank was removed, clean and dry the tank drain stem
receptacle in the base.
 After cleaning, reinstall the wash tank, making sure the drain stem with the O-ring seats
in the drain receptacle by pushing down straight until the tank’s feet touch the base floor.
22..
Carefully lift the thermistor arm up until it locks in place (and remove the transport if it is still
installed). Remove the developer and fixer tanks and dispose of the old chemistry in accor-
dance with local codes.
33..
Rinse and, using separate color-coded sponges to avoid possible contamination, clean both
tanks. Rinse again and wipe dry with a lint-free towel.
44..
Reinstall the fixer (red) tank in the base. Fill with contents of the Peri-Pro fixer bottle. Pour
carefully to prevent splashing.
55.
.
Reinstall the developer (black) tank in the base. Fill with contents of the Peri-Pro developer
bottle. Pour carefully to prevent splashing and possible contamination. Lower the thermistor
arm into place in the developer tank.
NNoottee::
Peri- Pro chemistry should be at or below 75°F.
RReeaasssseemmbbllee tthhee PPeerrii--PPrroo IIIIII
11..
Slowly and carefully lower the film transport straight into the tanks. The film transport must sit
squarely on the cutouts found on the top of the vertical plates to the left and right side of the
tanks.
22..
Insert the film inlet grill on top of the transport.
33..
Install the cover with the refill access door in front. Hang the film delivery receptacle on the
cutout at the dryer end of the cover.
44..
Plug the line cord into a 115V outlet and turn the
PPOOWWEERR
switch
OONN
.
9
FIG. 12