User`s manual

MAINTENANCE
Servicing your Peri-Pro III on a daily, two week and quarterly basis is critical to maintaining quality
processor performance. We recommend the maintenance procedure outlined below, using Formula
2000 cleaner, and Peri-Pro Developer and Fixer, which are specially formulated for Peri-Pro proces-
sors. This maintenance schedule may have to be modified if more frequent cleaning is required.
DDAAIILLYY -- CCHHAANNGGEE WWAATTEERR
TTOOPP OOFFFF CCHHEEMMIISSTTRRYY TTAANNKKSS WWIITTHH WWAATTEERR TTOO FFIILLLL LLIINNEE
NNoottee::
Remember to place the wash water drain tube into a receptacle
large enough (at least 45 oz.) to hold the contents of the water tank
when it is drained. The best location for the receptacle is on the floor.
Dispose of wash water in accordance with local codes.
11..
Turn
PPOOWWEERR OOFFFF
.
22..
Find the water drain valve handle at the lower right hand corner of the processor base.
33
..
Open the drain by turning the handle a full 90° clockwise . Allow the water tank to drain
completely. If the tank interior appears soiled, rinse tank and drain completely.
44..
Close the drain valve by turning the handle a full 90° counterclockwise .
55..
Fill the Peri-Pro III water bottle to the Fill Line (40 oz.) with room temperature water (70° -
80°F). Extend the neck of the bottle and flex into position. Empty entire contents into the water
(white) tank.
66..
Check that the solution in the developer (black) and fixer (red) tanks are up to the Fill Lines as
indicated on the inside of the refill access door. If not, top off the developer and fixer tanks
with water.
77..
Close the refill access door to enable the processing of films.
88..
Turn
PPOOWWEERR OONN
to prepare for processing.
EEVVEERRYY TTWWOO WWEEEEKKSS ((oorr eevveerryy 330000 -- 335500 ffiillmmss))
SSCCRRUUBB TTRRAANNSSPPOORRTT;; CCHHAANNG
GEE PPEERRII--PPRROO CCHHEEMMIISSTTRRYY
CCaauuttiioonn::
Cleaning and changing chemistry requires the removal of
the cover and film transport from the Peri-Pro III. Always turn POWER
OFF and unplug the line cord before removing the cover or transport.
SSccrruubb TTrraannssppoorrtt
11..
Turn
PPOOWWEERR OOFFFF
and unplug the line cord. Remove the film receptacle, lift off the cover.
22
Lift the film transport and let the solutions drip back into the tanks before placing the transport
in a sink. (Use of optional Service Tray PN90121 will contain any dripping chemistry.)
33..
Rinse the transport thoroughly with warm water to soften residue and dried chemistry. Be sure
to rinse above the chemistry level, keeping the shutter and the film inlet on the top of the
transport dry. (Use a sink or the transport wash tub that comes with the Transport Cleaning Kit
PN 43975.)
8