User`s manual

OPERATION
PROCESSING FILM

PPrroocceessssiinngg ##00 ((PPeeddoo)) oorr ##11 ((AAdduulltt AAnntteerriioorr)) FFiillmmss
#0 and #1 films cannot be fed directly into the processor. These films fit into corresponding
# carriers (supplied with the processor), each of which carries the film through the processing
cycle. Up to six #0 or #1 films can be loaded into corresponding carriers at one time.
aa..
To load #0 or #1 film into the corresponding # carrier, nest
the carrier inside the tabs on the cover, next to the inlet grill.
bb..
Strip the cover off the film(s) and slide the film(s) vertically, one
at a time, into any of the six grooves on the carrier. Push down
firmly until the film touches the cover. Repeat until as many
grooves as required are filled. The films should be standing
vertically and parallel to each other, away from the centerbar.
Make sure that each film on the carrier is in its own groove.
cc..
Remove the film inlet grill. (Remember to replace it when processing
#2 films.) Insert the carrier, with the film(s) standing vertically,
into the film inlet.
dd
. Slide the shutter to the right until it latches. The carrier will drop into the transport and begin
processing when the shutter automatically opens.

PPrroocceessssiinngg ##33 ((BBiittee--WWiinngg))
FFiillmmss
#3 films cannot be fed directly into the processor. Use a #3 carrier that holds two films at a time.
aa..
Strip the cover off one or two #3 film(s) and slide the film(s) horizontally, one at a time,
through both side plates of the #3 carrier. Remove film inlet grill.
bb..
Insert the carrier into slots 3 and 6 in the
film inlet. Make sure the edges of the
film(s) clear the side walls of the film inlet.
cc..
Slide the shutter to the right until it latches.
The carrier will drop into the transport
and begin processing when the shutter
automatically opens.

PPrroocceessssiinngg ##44 ((OOcccclluussaall)) FFiillmmss
aa..
Strip the cover off one #4 film and carefully
bend almost in half. Slide the film into
the carrier, making sure both edges of
the film are held in place by the guide
tabs. Remove film inlet grill.
bb..
Place the carrier onto the film inlet with
the orientation arrow (on the side of the
carrier) pointing down.
cc..
Slide the shutter to the right until it latches. The carrier will drop into the transport and begin
processing when the shutter automatically opens.
55..
When processing is completed, turn the
PPRROOCCEESSSS
switch
OOFFFF
. The green
RREEAADDYY
light remains
lit. At the end of the day turn the
PPOOW
WEERR
switch
OOFFFF
. Both the green
RREEAADDYY
light and the
amber
PPOOWWEERR
light will extinguish.
7
FIG. 10
FIG
. 11
#0
#1
#3
#4
To assure complete drying of processed # 4 films, a manual assist may be needed,
if so;
1. While the fan is blowing, hold the open end of the film in the carrier directly over the
dryer grille, about 1”- 2” elevation is sufficient, and slowly pivot the carrier to have
warm air blow on the outer surface.
2. 30-60 seconds should be enough time to adequately dry film.
3. Unload the dried film from the carrier when done.