User`s manual

Appendix A: Emergency Firmware Upload

． Using AirLive WL-5460AP's Emergency Firmware Upload Feature

The emergency firmware upload feature is to help you restore the AP when the firmware is corrupted. If

you can no longer access the AP's web UI, please first try to restore-to-default by holding the Reset

button for more than 5 seconds. Then you should be able to find the AP at 192.168.100.252. But if

this still doesn't work, please follow the procedures below to restore the firmware.

1. Hold the "Reset" button in the back of the AP BEFORE plugging in the power.

2. After plug-in the power, wait until the "Status" LED goes off before releasing the reset button.

3. Visit

www.airlive.com. Go to Support->Firmware Download section. Download the WL-5460AP e10

firmware. Decompress the archive file into your PC.

4. Set your computer's IP address to 192.168.1.100. Open your browser and enter "192.168.1.6".

5. You should see the emergency upload page. Upload the WL-5460AP e10 firmware (or later) to the AP.

6. Wait for 3 minutes. Change your PC's IP to 192.168.100.100. You should be able to access the AP at

192.168.100.252.

49 WL5460AP v2 User’s Manual