User`s manual

41 WL5460AP v2 User’s Manual
Uptime The time period since the device was up.
Firmware Version The current version of the firmware installed in this device.
Wireless
Mode There are 7 modes supported, The default mode is Access Point. If you want to
change to other mode, please click the Mode and select the wireless mode you
want.
Physical Address Display wireless MAC address information.
Band Display wireless band type information.
SSID Display the SSID of this device.
Channel Number The number of channels supported depends on the region of this Access Point.
A
ll
stations communicating with the Access Point must use the same channel.
Encryption Display encryption setting information.
Associated Clients Displays the total number of clients associated to this AP. You can have up to 64
clients to associate to this Access Point.
BSSID BSSID displays the ID of current BSS, which uniquely identifies each BSS. In AP
mode, this value is the MAC address of this Access Point.
LAN Configuration (TCP/IP)
Connection Method: Display the connection method, you can setup in TCP/IP section
Physical Address: Display the LAN MAC address
IP Address: Display the LAN IP address, you can setup in TCP/IP section
Network Mask: Display the network mask, you can setup in TCP/IP section
Default Gateway: Display the default gateway ip , you can setup in TCP/IP section
DHCP Server: Default the DHCP Server is enabled(ON)
DHCP Start IP
Address:
Display the DHCP server start IP address.
DHCP Finish IP
Address:
Display the DHCP server finish IP address.
Internet Configuration
Connection Method: Display the internet connection method, you can setup in WISP modeÆWAN
Port configuration
Physical Address: Display the AP MAC address information
IP Address: Display the internet IP Address, you can setup in WISP modeÆWAN
Port configuration
Network Mask: Display the network mask, you can setup in WISP modeÆWAN
Port configuration
Default Gateway: Display the default gateway , you can setup in WISP modeÆWAN
Port configuration