User`s manual
61
3.11 Access Control
When Enable Wireless Access Control is checked, only those clients whose wireless MAC
addresses listed in the access control list can access this Access Point. If the list contains
no entries with this function being enabled, then no clients will be able to access this
Access Point.
Wireless Access Control Mode: Select the Access Control Mode from the pull-down
menu.
Disable: Select to disable Wireless Access Control Mode.
Allow Listed: Only the stations shown in the table can associate with the AP.
Deny Listed: Stations shown in the table won’t be able to associate with the AP.
MAC Address: Enter the MAC Address of a station that is allowed to access this Access
Point.
Comment: You may enter up to 20 characters as a remark to the previous MAC Address.