User`s manual

6. System
AirLive SD-2020 User’s Manual 53
- Detection Type
Input the IP device address and the period of ping time to ping. The ping time setting
range is from 1 to 99 minutes.
- Triggered Action (Multi-option)
The Administrator can specify alarm actions that will take when network failure is
detected. All options are listed as follows:
z Enable Alarm Output 1 /2
Select the item to enable alarm relay output.
z Record Stream to SD Card
Select the item and the alarm-triggered recording will be saved into your Micro SD
card.
Pre-trigger buffer recording function allows users to check what happened to
cause the trigger. The pre-trigger buffer time range is from 1 to 3 seconds. Select
<Upload for __ sec> to set the recording duration after alarm is triggered. The
setting range is from 1 to 99999 seconds. Select <Upload during the trigger
active> to record the triggered video until the trigger is off.
NOTE: Please make sure the local recording (with Micro SD / SDHC card) is
activated so that this function can be implemented. Refer to section Recording for
further details.
z Send Alarm Message by FTP/E-Mail
The Administrator can select whether to send an alarm message by FTP and/or
E-Mail when an alarm is triggered.
- Save
Click on the <Save> button to save all the settings mentioned above.