User`s manual

6. System
AirLive SD-2020 User’s Manual 50
z Upload Image by E-Mail
Select this item and the Administrator can assign an e-mail address and configure
various parameters. When motion is detected, event images will be sent to the
appointed e-mail address.
Pre-trigger buffer> function allows users to check what happened to cause the
trigger. The <Pre-trigger buffer> frame rate could be pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain amount of
images after the motion event occurs.
Check the box <Continue image upload> to upload the triggered images during
certain time or keep uploading until the trigger is off. Select <Upload for __sec>
and enter the duration in the blank. The images of the duration will be uploading
by E-mail when the motion event occurs. The setting range is from 1 to 9999
seconds. Select <Upload during the trigger active> to make the images keep
being uploaded to E-mail during the trigger active until the event stops. Set the
Image frequency as the upload frame rate. The setting range is from 1 frame to 15
frames.
NOTE: Make sure SMTP configuration has been completed. Refer to section Mail
for further details.
z Send HTTP notification
Check this item, select the destination HTTP address, and specify the parameters
for event notifications by <Motion Detection> triggered. When an alarm is
triggered, the notification can be sent to the specified HTTP server.
For instance, if the custom parameter is set as” action=1&group=2”, and the HTTP
server name is” http://192.168.0.1/admin.php”, the notification will be sent to
HTTP server as” http://192.168.0.1/admin.php? action=1&group=2” when alarm is
triggered.
z Record stream to SD Card
Select this item and the Motion Detection recording will be stored in Micro SD /
SDHC card when motion is detected.
Pre-trigger buffer recording function allows users to check what happened to
cause the trigger. The pre-trigger buffer time range is from 1 to 3 seconds. Select
<Upload for __ sec> to set the recording duration after motion is triggered. The
setting range is from 1 to 99999 seconds. Select <Upload during the trigger
active> to record the triggered video until the trigger is off.