User`s manual

6. System
AirLive SD-2020 User’s Manual 49
Meanwhile, when the value is bigger, the red horizontal line in the motion
indication window will be lower accordingly.
z Time interval (sec) [0-7200]:
The default interval is 10. The value is the interval between each detected motion.
z Triggered Action (Multi-option)
The Administrator can specify alarm actions that will take when motion is detected.
All options are listed as follows:
z Enable Alarm Output 1/2
Check the item and select the predefined type of alarm output to enable alarm
relay output when motion is detected.
z Send Alarm Message by FTP/E-Mail
The Administrator can select whether to send an alarm message by FTP and/or
E-Mail when motion is detected.
z Upload Image by FTP
Select this item and the Administrator can assign a FTP site and configure various
parameters. When motion is detected, event images will be uploaded to the
appointed FTP site.
<Pre-trigger buffer> function allows users to check what happened to cause the
trigger. The <Pre-trigger buffer> frame rate could be pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain amount of
images after motion event occurs.
Check the box <Continue image upload> to upload the triggered images during
certain time or keep uploading until the trigger is off. Select <Upload for __sec>
and enter the duration in the blank. The images of the duration will be uploaded to
FTP when the motion event occurs. The setting range is from 1 to 9999 seconds.
Select <Upload during the trigger active> to make the images keep being
uploaded to FTP during the trigger active until the event stops. Set the Image
frequency as the upload frame rate. The setting range is from 1 frame to 15
frames.
NOTE: Make sure FTP configuration has been completed. Refer to section FTP
for further details.