User`s manual

2. Package Contents and Installation
AirLive SD-2020 User’s Manual 10
z Make a cable entry hole on the wall to recess the cables. Otherwise, users
could push up the cable entry board on the Standard Wall Mount’s mounting
plate to place the cables.
z Fix the Standard Wall Mount on the wall with proper screws and screw anchors.
z Attach the Waterproof Rubber to the Standard Wall Mount.
z Run the cable(s) through the Standard Wall Mount.
NOTE: Please block the cable entry hole with the supplied sponge to avoid
insects entering the Wall Mount.
z Thread the cable(s) through the Mounting Kit and join the Mounting Kit to the
Standard Wall Mount with the supplied screws and washers. Then, adjust the
Waterproof Rubber to the joint.
z Connect the cable(s) to AirLive SD-2020.
z Join AirLive SD-2020 to the Mounting Kit with the supplied screw and washers.
2. Connecting to LAN (“A”)
You can use the provided Ethernet cable to connect the camera to your local area
network (LAN). When you connect the AC power adapter, the camera is powered on
automatically. You can verify the power status from the Power LED on the Ethernet
port. Once connected, the Link LED starts flashing green light and the camera is on
standby and ready for use now.