User`s manual

2. Package Contents and Installation
AirLive SD-2020 User’s Manual 7
1. RJ45 LAN socket: Connect to PC or Hub/Switch.
For connections to 10Base-T Ethernet or 100Base-TX Fast Ethernet cabling. This
Ethernet port built N-Way protocol can detect or negotiate the transmission speed of
the network automatically. Please use Category 5 cable to connect the Network
Camera to a 100Mbps Fast Ethernet network switch or hub.
In the LAN socket, there are two LEDs embedded:
LAN LED (green color)
Green Link Light indicates good network connection.
Power (orange color)
This LED is used to indicate whether DC power is on or not.
2. Alarm I/O:
AirLive SD-2020 supports 4 digital alarm inputs and 2 digital alarm outputs. Please
make sure the alarm connections are properly wired before starting to configure alarm
related settings in section “SystemÆApplication (Alarm Settings).”
Please refer to the pin definition table below for alarm system wiring.