User`s manual

5 Management Software Guide
MIB Counter Submenu
You can view the MIB counter about the RX, TX and Diagnostic Counter. Click the Diagnostic
Counter column header, there are three object you can select, such as Drop count, CRC error count
and Collision count.
Byte Count Button
You can set the unit of the RX and TC counter to Byte count.
Packet Count Button
You can set the unit of the RX and TC counter to Packet count.
Bandwidth Utilization Button
Displayed the per-port traffic utilization. It will set the TX, RX and Diagnostic Counter to utilization
mode.
About Polling
 You can start counter by click the Start button, and click the Stop Button to stop.
 Clear Counter button is use to clear all MIB counters, it will reset the counters to 0.
 Polling interval button is used to set the time interval for the frequency of queried.
20
Ether-FSH2400RS Fast Ethernet Switch User’s Manual V1.0