User`s manual

2 Preparation before Installation
You can turn the power switch on /off to activate/deactivate the Switch. To turn on the Switch, press
the switch to the ON position. To turn off, press the switch to the OFF position.
AC Power Connector
This is a three-pronged power connector where the power cord should be attached. Just plug the
female end of the power cord into the connector, and the male end of the power cord into an AC
power outlet. The switch supports an input voltages ranging from 100 ~ 240 V
AC
@ 50~60 Hz .
Power Switch
Power Connector
Fig. 2-4 Rear Panel
8
Ether-FSH2400RS Fast Ethernet Switch User’s Manual V1.0