User`s manual

5 Management Software Guide

Introduction

The Airlive Windows remote management software allows user to configure the management

function though the LAN port. It uses a specialized RRCP protocol and does not use the IP protocol.

It operates inside the Ethernet network. Comparing to the Ether-FSH2400R, the Ether-FSH2400NS

includes a memory management unit (MPU) to allow switch settings be stored inside the flash

memory and enable the authentication key function.

Important Information

 WinPCap 3.1 (included in the CD) must be installed before using the management software

 Most of the setting options show up when you right click on the screen using your mouse.

 Please make sure to press the “Apply” button after changes

 Please make sure to “write to the switch” after change settings

 The Ether-FSH2400NS has a factory reset button on the right side of the front panel. This

button will restore switch’s setting to factory’s default values.

 If your management program can’t find the switch, please press the reset button.

Minimum system requirements

To use Remote Management Application, it is necessary that your system include the following

components:

Hardware

 Pentium class processor

 128 MB RAM

Software

 Windows® 98 SE, Win2000, or WinXP

 WinPCap 3.1 (included in the CD)

Ether-FSH2400NS Fast Ethernet Switch User’s Manual V1.0