User`s manual

4 LED Indicators
4 LED Indicators
Before connecting any network device to Ether-FSH2400NS Fast Ethernet Switch, you should take
a few minutes to look over this chapter and get familiar with the front panel LED indicators of your
Switch.
System LEDs
- Power (green) to indicate power on/off status
- Loop (yellow) to indicate network loop has formed inside the network. You can use
the management program’s diagnostic function to find out which port the loop occurs.
This function will work only after you enabled the Loop Detection using the
Management Utility.
- Trunk (RED) indicate when the Trunking function is enabled using the management
utilty
Station Port LEDs
For port 1 ~ port 24
- Link/Act (green) to indicate linking status and activity
- FDX/Col (yellow) to indicate Full Duplex transmission mode and collision status
- 100 M LED (red) to indicate 100 Mbps speed
12
Ether-FSH2400NS Fast Ethernet Switch User’s Manual V1.0