Instruction manual

AM.11.100e edition 1.4
Chapter 4: Servicing in the Maintenance Base 27
How to replace the lamp
When used, always replace the film disc cut-out each time a lamp has to be
replaced.
To replace a lamp, proceed as follows:
Step Action
1
Open the light assembly ( see page 25).
2
Unplug the lamps fast-on connectors from the terminal block (F1).
3
Pull out the lamp (E3) from underneath, take care for the lamp spring
(E6).
4
If a cut-out (F14) is used, remove it by loosening the screw which
secures the cut-out clip to the terminal block and rotate cut-out clip free.
5
If a cut-out is used, position a new disc (small button side up) in the
terminal block. Rotate the cut-out clip on top of the cut-out and hold
while tightening the screw. Make sure that the pressure applied by the
clip on the film disc is sufficient to assure good contact. If loosened,
remove the clip and bend it slightly to increase its pressure.
Film disc
cut-out
Procedure
Lamps fast-on
connectors
Lamp E3
Lamp spring E6
F1 terminal block
Cut-Out
F14