Instruction manual

AM.11.100e edition 1.4
Chapter 4: Servicing in the Maintenance Base 25
How to open the light assembly
To open the light assembly, proceed as follows (for the tools to use, refer to,
page 44"Screws Overview "):
Step Action
1
Turn the light unit upside-down. In order for the light to rest on a stable
surface it is advised to lay it upside down on the top of a shallow base.
2
Remove the pressure release screw (F9).
3
Remove the four screws (F4). The use of an attack driver may be
required to unlock the screws (see page 48).
• Always use a new bit for each light requiring the use of an attack
driver.
• Take care that the bit is well positioned on the screw head and
that the driver is aligned with the axis of the screw.
Procedure
F9 / F12
F4