Instruction manual

AM.11.100e edition 1.4
Chapter 2: Mounting and connection 16
General recommendations
Upon receipt of goods at the site store, check all packings for visible damage.
Every damaged box should be opened and its content inspected for damage.
If equipment is damaged, a claim form shall be filed with the carrier immediately. It
may then be necessary for the carrier to inspect the equipment.
Store the light assembly preferably in its original packing in a protected area. When
stored unpacked, please take care not to damage the cable insulation.
Unpack the light assembly at the installation site to avoid damage during
transportation and handling.
The light assemblies covered by this manual are designed for connection to either
series circuits via one L-830 or L-831 series transformer or to a 230V AC parallel
circuit.
Refer to ADB cat. leaflet A.06.112 or Instruction manual AM.06.112 for more
information on series transformers.
The series transformer has to be ordered separately.
Whatever the chosen installation method, it is strongly recommended to earth the
base, especially in locations presenting a risk of lightning strikes.
Failure to earth correctly the base will void the warranty for all damages occurring
as a result of voltage surges.
Note: Guidelines on how to realize the earthing of the base are given in
instruction manual Am05.120
The applicable documents for location details and tolerances are the following:
Organisation Applicable documents
ICAO Annex 14
Aerodrome Design Manual Part 4
FAA Advisory Circular AC no. 150/5340-28
Receiving,
storage and
unpacking
Electrical
connection
Base Earthing
Location and
tolerances