Installation Manual

14
MN-772
WirelessAIR
Recalling the Presets
• Tap the M1 or M2 buttons to send the Memory 1 or Memory 2 settings as the new
desired pressures.
• LCD Function
• The LCD will display the desired pressures for 2 seconds.
• The LCD will then display the actual spring pressures until the actual
pressures equals the desired pressures.
Saving Presets
• Press and hold the M1 or M2 buttons to save the current desired pressure to the
Memory 1 or Memory 2.
• LCD Function
• LCD will display “St” on the left side of the screen to indicate it will be
storing the desired pressure to Memory.
• LCD will display “r 1” or “r 2” on the right side of the screen to indicate
the Memory location.
• Once the “Str” is displayed on the LCD release the button to save the pressure to
memory.
LCD storing memory
LCD storing memory rear 1
Error messages
• Leak Detection
• The controller will activate the LEAK icon on the controller when a leak has
been detected.
• Blockage Detection
• The controller will display “BL OC” to indicate there is a failure preventing an
air spring from inating or deating.
• Compressor Inoperable
• The controller will display “CO INP” if the compressor has run for too long and
is in danger of overheating.
g. 15
g. 16