Installation Manual

12
MN-772
WirelessAIR
SLEEP MODE
The controller features a sleep mode to preserve the battery life. In this mode the manifold
is still active and will maintain the desired spring pressures.
• In Normal Mode if no button has been pressed for 30 seconds the controller will
enter Sleep mode.
• LCD will only display the AIR LIFT Logo.
• Backlight and radio are turned off.
• Any button press will recover to Normal Mode.
If the controller does not go into Sleep Mode after 30 seconds, change the pressure by one
or two PSI. The controller will then go into Sleep Mode after 30 seconds.
LCD in Sleep Mode
NORMAL MODE
• The normal operating mode is used to adjust pressure of the air springs. To enter
normal mode from sleep mode press any button. To enter the settings mode press
the UP and DN buttons together.
• To exit the settings mode press M2.
Increasing and decreasing desired pressure:
• Initial press of any button will wake up display and not perform any function.
• Upon wake up the LCD will display the last desired pressure.
• If pressure adjustment is needed select the air springs you would like to adjust.
• Using the NAV PAD left and right buttons, you can select/deselect the air
springs to adjust.
• The selection arrows will indicate which springs are selected.
LCD with only right spring selected
LCD with left and right springs selected
g. 9
g.10
System Operation
g. 8
NOTE