Installation Manual

11
MN-772
WirelessAIR
The controller has a LCD to provide the user feedback of system operation. This LCD
will display air spring pressures, provide status of the system, and display fault detection
messages.
Controller LCD
ICON DEFINITION
Battery is displayed when the battery voltage in the controller is low, a
low battery voltage may prohibit a high strength wireless transmission
and may result in a failed transmission.
Transmission Indicator is displayed when the controller is actively
communicating with the Manifold.
Fail Indicator is displayed when we have any failure of the system for
example, communication failure, valve blockage, or a leak.
Compressor Indicator is displayed when the compressor is running and
the system is lling a spring to the desired pressure.
Unit of measure will be indicated per the user setup.
Exhaust arrow will be displayed when the manifold exhaust valve is active
and the system is exhausting a spring to the desired pressure.
Accessory Icon will be active in the Settings mode.
g. 7