Instructions / Assembly

NOTE: If the fan motor plug
is connected to the fan
housing receptacle, unplug so
the blower assembly can be
completely removed.
2. Continuous Ventilation: For two speed fans wired for continuous ventilation, connect
the White wire of the fan to the White (Neutral) wire from the power source. Connect
the ground wire from the house to the green wire from the fan housing. Run 2 wires
from a properly grounded wall switch (not included) to the fan. Connect the Blue
wire of the fan and one wire from the wall switch to the Black wire (Hot) from the
power source. Connect the other wire from the wall switch to the Black wire of the
fan. Closing the switch will change from normal to high speed (Figure 8).
3. Intermittent Ventilation: For two speed fans wired for intermittent ventilation with
the recommended AKS2 Switch (not included). Connect the White wire of the fan
to the White (Neutral) wire from the power source. Connect the ground wire from
the fan to the ground wire from the power source. Properly ground the switches.
Run a wire from the Blue wire in the fan to the Common terminal (Black Screw)
of the AKS2 Switch. Connect the Black wire from the power source to the silver
terminal on the bottom of the AKS2 Switch. Connect the Black wire from the fan to
the silver terminal on the top of the AKS2 Switch. The Bottom switch will turn the
fan on & off, the top switch will change between high and low (Figure 9).
NOTE: Unit must be grounded according to all local and national codes.
4. Reinstall both the wire compartment cover and the fan’s venturi by reversing the
instructions in Step 1b of Section 5 Wiring. Make sure all wires are contained
within the wire compartment.
www.airkinglimited.com
A210952011 New 8-10 3 of 12
SECTION 6
Completing the Installation
1. Plug the fan’s quick connect motor cord into the receptacle located on the wire
compartment cover. The cord will only fit one way into the receptacle (Figure 10).
2. Install the grill by squeezing the two ends of the springs together and installing them
up into the slots on the fan’s housing. Push the grill up into position (Figure 11).
3. Restore power and test your installation.
SECTION 7
Use and Care
CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL
BEFORE STARTING INSTALLATION.
1. Cleaning the Grill: Remove grill and use a mild detergent, such as dishwashing
liquid, and dry with a soft cloth. NEVER USE ANY ABRASIVE PADS OR SCOURING
POWDERS. Completely dry grill before reinstalling. Refer to instructions in Section
6 Finishing the Installation, to reinstall grill.
2. Cleaning the Fan Assembly: Wipe all parts with a dry cloth or gently vacuum the
fan. NEVER IMMERSE ELECTRICAL PARTS IN WATER.
Figure 10
Screw
Wire
Compartment
Cover
Screw
Figure 7
Wire
Compartment
Cover
Figure 8
Supply from
house
Hot (Black)
Blue
Black
Blue
Switch
Neutral
(White)
Ground (Green or Bare)
Figure 11
Figure 9
Supply from house
Hot
(Black)
Blue
Black
Switch
Fan
Ground (Green or Bare)
Neutral (White)