Specifications

39
3939
39
CONDITION
CONDITIONCONDITION
CONDITION POSSIBLE CAUSE
POSSIBLE CAUSEPOSSIBLE CAUSE
POSSIBLE CAUSE CORRECTION
CORRECTIONCORRECTION
CORRECTION
Snowplow angles move slowly or partially.
1) Hydraulic fluid level low or incorrect fluid is
used.
2) Vehicle battery weak or malfunction is charg-
ing system.
3) Air in angle cylinders.
4) Angle cylinders damaged or leaking.
5) Motor worn or damaged or fault in wiring.
6) Pump filter clogged, worn or damaged pump,
or hydraulic system malfunction.
1) Fill reservoir to proper level with recom-
mended fluid.
2) Replace battery and/or check charging sys-
tem.
3) Cycle plow to remove air.
4) See an Air-Flo dealer for repair information.
5) See an Air-Flo dealer for repair information.
6) See an Air-Flo dealer for repair information.
Snowplow will not lower, lowers slowly, or will
not float.
1) Hydraulic fluid is incorrect for outside tem-
perature.
2) Quill adjusted in too far.
3) Blown fuse.
4) Cab control or hydraulic system malfunction
or fault in wiring.
1) Use recommended fluid.
2) Adjust Quill out.
3) Replace fuse.
4) See Air-Flo dealer for repair information
Snowplow lowers by itself or will not stay in the
raised position.
1) Hydraulic fittings or hoses loose or damaged.
2) Cab control or hydraulic system malfunction.
1) Tighten or replace components or see an
Air-Flo dealer for repair information
2) See an Air-Flo dealer for repair information.
Manual.pub
tile 1 of page 41 Cyan Magenta Yellow Black
Cyan Magenta Yellow Black
Friday, November 17, 2006 12:29