User's Handbook

6
Sight assembly.
If you wish to use the sights supplied with your
Multi Purpose Rifle they first have to be fitted to the
gun.
The set of sights supplied comes in 2 pieces, Fig
5, the front sight and rear sight, and both fit onto
dovetail mountings on the rifle.
Firstly making sure that the thumb screw is
loose, slide the rear sight onto the dovetails and into
position Fig 6. Once the sight is in position, the
thumb screw can be tightened, being careful not to
over-tighten the screw Fig 7. When the sight is on the
dovetail it can be moved forwards and backwards to
establish the proper eye relief for each position.
If not already fitted, fit the riser block to the bottom of the front sight Fig 8. Note: If the riser
block is not fitted on the barrel the rifle cannot be properly sighted in.
The sight can now be fitted into the dovetails on the muzzle Fig 9.
The sight tunnel should be fitted with the screw on the left side facing the rear of the gun. When
in place the screw can be tightened Fig 10 , care must be taken as the screw and nut are mounted
into the plastic moulding and over tightening will damage the sight.
.