User's Handbook

To adjust the cant and slope of the fore-end, loosen the three screws in the side of the clamp.
It is best not to loosen the screws all the way as this will make it more difficult to hold the position
of the fore-end. Once the desired position is achieved re-tighten the screws evenly until the clamp is
secure.
CHEEK PIECE
The cheek piece can be raised and lowered in the stock by loosening the screw in the side
of the stock. With the screw loose, position the cheek piece to the required height and re-tighten
the screw (do not over tighten). Extender rods are available as an accessory if the adjustment is not
enough from the standard rods supplied. Please contact your stockist or Air Arms.
67
Adjustment screws allow positioning of the
fore-end piece, a small amount of front to
back tiliting can be achieved. The side clamp
screw (66) needs to be loosened to allow
pillar movemement
7
Cheek piece rod locking
screw. Allows the cheek
piece to be raised and
lowered
20
Cheek piece rail screw. Al-
lows the cheek piece to move
from side to side and back to
front
19
Controls the ball
join
t