User manual

27 Version 1.0
Choose your WAN type as the above mentioned, and its associated settings will show up
underneath at the same time.
3.2.1.1 WAN Type – Static IP
Choose Static IP Address if all WAN IP information is provided to you by your ISP. You will
need to enter the IP address, IP Netmask and IP gateway as provided. Each entered fields
must be in the appropriate IP form, which are four IP octets separated by a dot (x.x.x.x). The
Router will not accept the IP address if it is not in this format. If ISP provides you DNS
information, please select Specify DNS Server IP and fill in Primary field at least;
otherwise, Domain Name can’t be used.
In particular, here provides 3G or 3.5G transmission rate when the device is plugged, either
a 3.5G USB Dongle or Card Bus; just check to apply for the backup. In other words, once
Static IP connection is disconnected, the system automatically connects Internet via 3.5G
adapter. If 3.5G signal is not available, it starts to search downward for 3/2.75/2.5G signals
until none existed. The default interval between the two connection detection is 3 minutes.
The interval range is from 1 to 3 minutes.
The 3.5G feature is working as mutual backup for other 4 WAN Types, and the required
information is listed as follows, such as user name, password and SIM PIN etc. That is,
setting up the interval time to auto detect whether the Internet connection is lost or not. If
yes, the system immediately switches to 3.5G Internet connection until the original Static IP
connection is back during the next detection.
See 3.2.1.1
See 3.2.1.2
See 3.2.1.3
See 3.2.1.4
See 3.2.1.5