User manual

214 Version 1.0
Rule1: After connecting USB devices, please reboot your Router.
Rule2: Before finishing the DHCP setup, please don’t connect any computer to LAN
ports, because the conflict of having the same IP may occur and cause some
computers a lot of trouble.
※ Notice: Make sure that you always click on the Apply button after
configuring each setting. And in order to let other LAN ports work properly,
please reboot your PC.
3. Q: I don’t know how to configure DHCP.
A: DHCP is commonly used in the large local network. It allows you to manage and
distribute IP addresses from 2 to 254 throughout your local network via MT4205.
Without DHCP, you would have to configure each computer separately. It’s very
troublesome. Please Open Internet browser > Input 192.168.1.1 in the website
blank field > Select DHCP Server under the IP Config Menu. For more
information, please refer to 3.3.2 (Router Mode) or 4.3.1 (AP Mode).
4. Q: How do I upgrade the firmware of MT4205?
A: Periodically, a new Flash Code is available for MT4205 on your product supplier’s
website. Ideally, you should update MT4205’s Flash Code using Firmware Upgrade
on the System Management menu of MT4205 Settings.
5. Q: My MT4205 cannot connect to the ISP?
A: There are three possible solutions.
1. Check the Cable/XDSL modem is power on.
2. Check the Cable/XDSL link light is on to verify a good physical connection.
3. Check the WAN port LED to verify if the Cable/XDSL modem is connected to the
router:
If your ISP Login method is following, please make sure the username and
password are correct or not.
If your ISP is using dynamic IP addressing (DHCP) then the DHCP protocol does not
have the authentication feature. Some Cable service providers often use the
following to determine user’s identification.
6. Q: Why is that I can ping to outside hosts, but cannot access Internet websites?