User manual

111 Version 1.0
1 and 253 that is not used by another device.) Please don’t change the default LAN IP
settings at this section until after you have completed the rest of the configurations and
confirm that your Internet connection is working. And the DHCP Server will automatically
allocate an unused IP address from the IP address pool to the requesting computer; which
means you must specify the starting and ending address of the IP address pool, and the
DHCP Router’s address must be identical to the LAN IP’s IP address.
Click on Next button to proceed.
4.2.2 Wireless Setup
There are 2 ways of hardware connection via Wired upper link and Wireless upper link.
First step is to name your ESSID, and the default value is Wireless_Mobile_Router.
Please follow the illustrations below to proceed.
For selecting AP/Bridge wireless connection, the Channel 6 is the default channel; all
devices on the network must be set to the same channel to communication on the network.
The default TxPreamble setting is Long (if you use high traffic networks should use the
shorter preamble type). Authentication is the security function to prevent the connection
Select AP/Bridge from the drop-down list.
You can use the default ESSID
unless more than one AP/Router
is deployed in the same area.
And it will show while searching
the wireless signal.