Operation Manual

MyNote Bluetooth Manual EN

www.aiptek.eu Page 5

Power LED: Blink slowly in standby mode; blink quickly during writing.

Battery Status: Blink slowly during charging or when battery is low; steady on when fully

charged.

Bluetooth LED: Blink slowly when bluetooth is on.

Getting started

1. Charge the Battery of the Base Unit

Before using MyNote Bluetooth the first time, the battery needs to be charged.

Connect the device with the supplied USB cable trough the USB connector and

the other side to a powered PC, Mac or notebook. After 3 hours the unit is fully

charged and ready to use. Alternative you can use an optional 5V DC USB

charger which can be purchased in Aiptek webshop. (www.aiptekshop.de)

2. Prepare the pen

Before first time usage the batteries and pen tip must be installed.

a. Remove the battery compartment cover on top of the pen. Do not

attempt to open the other part of the pen itself. This may cause the

pen to malfunction.

b. Install the two SR41 batteries, with the positive poles (+) facing

up.

c. Close the battery compartment cover.

d. Place the pen tip in the pen and gently push it

in until the end is reached. Don’t use to much

pressure to avoid damage of the pen.

3. Power On

The device turns on automatically once you open the folder, the

indicator starts blinking. Put the f older on a flat surface and make sure that

the base unit i s located on top of the paper and the holes of the

receiver are not covered.